Via the connected E+L controller interface (e.g., the command panel DO 2000 or a specialized touch interface), select the sensor calibration menu and trigger the "Uncovered / Background" calibration baseline.
Mounting instructions and wiring diagrams for connecting to digital controllers (such as the DC 55 series). Commissioning:
Ensure the system receives the required power supply voltage.
Remove all material from the sensor’s measuring path so it only scans the exposed background. Erhardt-leimer Do 3001 Manual
Using the DO 3001 interface correctly is vital for maintaining web position accuracy
Here is a cheat sheet directly derived from the , Appendix A:
To operate the Erhardt-Leimer Do 3001:
If the web weaves back and forth aggressively (hunting), your is set too high. Lower the value.
: Manages precision web alignment by processing signals from edge sensors and directing correction signals to actuators (e.g., pivoting frames or steering rollers).
What (e.g., DO 20, DO 30) is the sensor connected to? Via the connected E+L controller interface (e
Avoid mounting the sensor where the material can scrape against the upper or lower forks of the housing. This can cause physical wear or deposit debris on the optical lenses. 3. Cabling
Proper mechanical alignment is critical to ensure the DO 3001 delivers accurate feedback data to the web guiding controller. Mounting Position
: Secure mounting of the command station and connecting it to the digital controller using specialized serial or CAN bus cabling. Setup & Commissioning Remove all material from the sensor’s measuring path