English
中文
日本語Selmarturbo4batterychargerinstructions
If left connected indefinitely, it will continue to push current into a full battery. This causes the internal chemicals to overheat, boil off the water inside, and warp the internal plates, permanently destroying the battery. Troubleshooting Common Issues The ammeter needle doesn't move or stays at zero
If the ammeter stays pinned at its highest reading for many hours without dropping, the battery may have a shorted internal cell and cannot hold a charge. Discontinue charging, as the battery needs to be replaced.
: The charger may have tripped an internal thermal fuse. Unplug it and let it cool down for 30 minutes. The charger hums loudly selmarturbo4batterychargerinstructions
connect the charger to the battery before plugging it into the mains.
Your Selmar Turbo 4 uses a simple light system. Here is the decoding chart: If left connected indefinitely, it will continue to
When the ammeter needle has been very low for an hour or more, the battery is fully charged.
Set this powering on.
| Ammeter Reading | Likely Meaning | Recommended Action | | :--- | :--- | :--- | | | The battery is deeply discharged and drawing maximum current. | Monitor the battery for overheating. | | Needle is medium (e.g., around 2-4) | The battery is partially charged and accepting current well. | Continue charging as normal. | | Needle is very low (e.g., 1 or below) | The battery is fully charged and drawing minimal current. | Stop charging to prevent overcharging. |
(If charging while the battery is still inside the vehicle, connect the Red clip to the positive post, and the Black clip to a heavy, unpainted metal part of the engine block or chassis away from the battery and fuel lines). Step 4: Turn On the Charger Discontinue charging, as the battery needs to be replaced