The system is now reset to factory defaults. The Master Code reverts to , and all system settings return to standard configuration. Note: User data (cards and PINs) will not be deleted during this hardware reset. Troubleshooting
Normally Open Relay output. Used for Fail-Secure locks (e.g., Electric Dropbolts/Strikes that require power to unlock). V2000-c Rfid Access Control User Manual
The V2000-C is a "Standalone" unit, meaning it does not require a constant network connection to work, but it can connect for management. The system is now reset to factory defaults
| Component | Function | |-----------|----------| | | Place card to read | | Keypad (0–9, *, #) | PIN entry and programming | | Red LED | Power/Denied | | Green LED | Access granted | | Buzzer | Keypress/status feedback | | Relay output | Connects to electric lock (NO/NC/COM) | | Exit button input | Wired momentary switch | | Door contact input | Monitor door open/closed | Troubleshooting Normally Open Relay output
| LEDs | Status | Meaning | |:-----|:-------|:--------| | Red only | Steady | System powered, idle mode | | Green + Red | Flashing | Card reading in progress | | Orange + Red | Steady | In programming mode | | Red + Green + Orange | Flashing | Initialization mode | | Green | Flash once | Access granted |
If you forget your master code, you can reset the master code back to factory default without wiping your existing enrolled users: Power down the V2000-C unit completely. Press and hold down the * key on the keypad. Turn the power back on while continuing to hold the * key. Release the * key after you hear two short beeps.
Before installing the V2000-C RFID access control system, ensure that you have the necessary tools and materials. The installation process involves the following steps: