Redsail Cutting Plotter Usb Driver Install Page
section to find your device, listed as "USB Serial Port" or "USB-SERIAL CH340" followed by a port number (e.g., Configure Your Software Open your cutting software (like SignMaster Go to the output/cutter settings and select the Ensure the matches the COM number found in Device Manager and set Flow Control
Note: If your device manager shows a yellow exclamation mark next to the port, the driver did not install correctly. Proceed to the troubleshooting section below. Step 5: Configure Your Cutting Software
With the driver installed and the COM port verified, configure your sign-making or design software (such as ArtCut, SignCut, FlexiSign, or Sure Cuts A Lot). Launch your cutting software.
The most common reason is inside the software. Make sure the COM port number in your cutting application matches the COM port shown in Device Manager. Also verify that the baud rate and other serial parameters match your plotter’s settings (typically 9600 baud, 8 data bits, no parity, 1 stop bit). Finally, ensure the plotter’s green LED is lit (Online mode) – the plotter will not accept data when it is offline.
Open your cutting software (e.g., ), go to the plotter settings, and ensure the port is set correctly. Try a test cut to confirm communication. Summary Checklist Download drivers from Redsail. Run installer as Administrator. Connect plotter after driver setup. Verify in Device Manager (COM port). Match COM port in software. redsail cutting plotter usb driver install
Right-click the downloaded driver installer file (e.g., setup.exe or CH341SER.EXE ). Select . Click Install or follow the on-screen prompts.
Commonly found in older models, budget variants, or certain regional versions.
Download the version (simplest for automatic installation) or the ZIP architecture file. Option B: CH340/CH341 Drivers
Some driver packages contain only .inf and .sys files. These are the raw driver files. Install them by: section to find your device, listed as "USB
Used for older or professional-grade models.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
To install the USB driver for a Redsail cutting plotter, follow these steps. Note that the specific steps might slightly vary depending on your operating system (Windows, macOS, Linux) and the model of your Redsail plotter. Always refer to the user manual or manufacturer's website for model-specific instructions.
Look for an entry named or CH340 (COMx) , where x represents an assigned number (e.g., COM3, COM4). Launch your cutting software
Change the output port from "File" or "LPT" to the exact you found in Step 4.
:
Every story begins with a challenge. You have unboxed your Redsail cutting plotter (likely an RS series like the RS720C, RS1360C, or a Jinan Redsail model). You connect the USB cable to your Windows PC, expecting the machine to spring to life in your cutting software (like FlexiSign, ArtCut, or SignMaster).