Ts1162: Installation Manual

For comprehensive technical support, refer to the full ⁠Tecom Catalogue or official Aritech documentation.

Tecom TS1162 Installation Manual: Comprehensive Guide to Installing the 3 LED RAS Keypad The Tecom TS1162 Remote Arming Station (RAS)

To adapt the TS1162 to your specific system (like a refrigerator vs. an incubator), you must configure its internal programming parameters. Hold the button for 3 to 5 seconds to enter this menu. Use arrows to toggle through codes, press SET to modify, and press SET again to store. Parameter Code Function Description Default Setting Adjustable Range HC Heating / Cooling Mode Selection H (Heating) / C (Cooling) D Hysteresis / Temperature Differential 0.1°C to 15°C LS Lower Limit Temp Setting Constraint -50°C to Setpoint HS Upper Limit Temp Setting Constraint Setpoint to 110°C CA Temperature Calibration / Offset -10°C to +10°C PT Delay Start Protection Timer 0 to 10 Minutes Parameter Explanations

Connect the leads of the included NTC thermistor or PT100 probe. Sensor wires do not have polarity, so either wire can go into either terminal.

Once wired and powered, test the TS1162 to ensure proper functionality: ts1162 installation manual

The TS1162 connects directly to the . The keypad can be placed up to 1.5 km away from the Challenger panel, provided the cabling infrastructure meets requirements. Wiring Terminals

The keypad comes pre-wired, simplifying this step.

: Use high-quality, twisted-pair shielded data cable (such as Belden 8723 or equivalent 22 AWG two-pair cable) for data transmission lines.

Follow the on-screen prompts to complete the installation wizard. For comprehensive technical support, refer to the full

Inspect terminal connections annually for tightness and signs of wear. Troubleshooting Common Issues Possible Cause Recommended Solution Circuit breaker is tripped Reset the circuit breaker. Loose terminal wiring Turn off power and check all wire connections. Intermittent Operation Supply voltage fluctuations Verify voltage with a digital multimeter. Overheating Ensure ventilation paths are clear of obstructions. Error Indicator Flashing System self-test fault Cycle the power off for 30 seconds, then restart.

This comprehensive guide provides step-by-step instructions for safely installing, wiring, and programming the TS1162 digital temperature controller. Section 1: Pre-Installation and Safety Guidelines

The TS1162 has inputs and outputs designed to control a door directly: Connect a normally open ( ) button for exiting.

Press down firmly on the ribbon mechanism chassis until it clicks securely into place, then close the main printer cover. 4. Driver Installation and Configuration Hold the button for 3 to 5 seconds to enter this menu

Wait 60 seconds for the internal processor to complete its boot sequence.

Place the base plate flat against your intended mounting surface (wall, brickwork, or pillar).

: Use the dedicated input for RTE control if required for the door.