Press SET . Use arrows to change to 500 (for 500:5 CT). Press PROG to save and go to P-02 .
Common display messages indicate specific installation or network issues:
: The Computer 8d Manual (PDF) includes detailed setup procedures and switching programs like 1:1:1 or 1:2:2.
You must define the sizes of your capacitor steps relative to the first step. For example, a 1:1:1:1 program means all steps are the same size. A 1:2:2:2 program means the first step is a base value, and subsequent steps are twice as large. 4. Connection / Reconnection Time circutor computer 8d96 manual full
C/K=ICKcap C / cap K equals the fraction with numerator cap I sub cap C and denominator cap K end-fraction ICcap I sub cap C
The unit features two sets of terminals (upper and lower) for wiring:
This is where most users turn first. The full manual includes: Press SET
: Insert the device into the panel cut-out and fasten it using the provided spring from the outside. Power Supply
Press and hold the button for more than 3 seconds to access the internal programming parameters. Use the Up/Down Arrow keys to change values and the ENTER/SET key to confirm and move to the next parameter. Key Programming Parameters 1. Current Transformer Ratio (C.T.)
The display should light up. It will show current cos φ. A 1:2:2:2 program means the first step is
: For technical specifications on the 96x96 mm series, see the Circutor Power Factor Regulator Manual .
If the regulator encounters irregular grid conditions or an internal component mismatch, it halts automatic sequences and displays specific fault patterns.
Supports configuration for up to 8 capacitor steps.
A 10 kvar step on a 400V grid with a 400/5A CT (Ratio = 80).
The second and subsequent steps are double the size of the first step. 1.2.4.4: Binary progression for finer control. 6. Operation Modes