Standard terminals are usually connected to L1 and N (or L1 and L2 depending on the model's voltage rating).
3-digit LED display with icons for real-time status. Capacitor Steps: Controls up to 8 steps (relay outputs). Measurement: True RMS measurement of current and voltage.
Ensures accurate readings even in networks with harmonic distortion.
Typically 230V AC or 400V AC (model dependent; verify nameplate). circutor computer 8d-96 manual
If the display shows alarms (e.g., no current signal), verify the CT connections and ensure the network is energized. Summary of Key Technical Data Specification Model Computer-8d-96 Go to product viewer dialog for this item. Type Power Factor Controller Mounting Panel-mounted (96 × 96 mm) Measurements True RMS ( Keypad Front Panel Keys Disclaimer: This information is based on standard Circutor 8D-96 Go to product viewer dialog for this item.
Unlike consumer electronics, industrial controllers like the 8d-96 are for first-time users. The manual provides:
For codes not listed here, the full manual is essential. Standard terminals are usually connected to L1 and
This is the most referenced section of the manual. It includes:
Proper wiring is the foundation of accurate power factor regulation.
Insert the unit into a 92x92 mm panel cut-out and secure it using the provided side springs. Measurement: True RMS measurement of current and voltage
Current Transformer (CT): The CT must be installed on the main line of the installation (Phase L1), capturing the total current of the loads and the capacitors.Voltage Measurement: The voltage connections should be taken from phases that are different from the phase where the CT is installed (typically L2 and L3) to allow the device to calculate the phase shift accurately.Relay Outputs: Connect the common terminal to the control voltage and each output (1 through 8) to the corresponding contactor coils of the capacitor steps. Initial Configuration and Programming
Improper installation can lead to electric shock or fire. Follow these verified steps from the Official Circutor documentation
"Dear Support, I am trying to locate a user manual for a legacy device: Circutor Computer 8d-96. I need the manual for configuration and communication parameters. Any PDF or scan would be appreciated."
: Before maintenance, the main switch must be disconnected, followed by a 5-minute wait to ensure capacitors are fully discharged.